|
Tests Performed |
| |
| Ramp Test |
| Select from average ramp down/up or ramp down with inertia correction factor. Also allows extrapolation of free-run and locked-rotor data, plus interpolation of specific speed or torque data points. |
| |
 |
| |
| Curve Test |
| Test speed, torque, amps, watts input, watts output and open loop parameters. Capable of adjusting sampling rate and using step or ramp from one load point to the next. |
| |
 |
| |
| Manual Test |
| Runs test from front panel of the Dynamometer Controller while computer acquires data. Allows adjustment of sampling rate. |
| |
 |
| |
| Pass/Fail Test |
| Checks amps, input watts (with optional Power Analyzer), speed, torque and output watts against user-defined values. |
 |
| |
| Coast Test |
| Counts degrees of revolution after power is removed. |
| |
 |
| |
| Overload toTrip Test |
| Loads and monitors temperature until the motors thermal cutout trips. |
| |
 |
| |
| |
|
